Ricoh Aficio SP 5210SF Network Guide - Page 41
For details about IEEE 802.1X authentication, see Configuring IEEE 802.1X. - default password
View all Ricoh Aficio SP 5210SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Interface Settings LAN Type When you have installed the wireless LAN board, select the method of connection. Default: [Ethernet] [LAN Type] is displayed when wireless LAN board is installed. If Ethernet and Wireless LAN are 1 both connected, the selected interface has priority. Ping Command Check the network connection with ping command using given IPv4 address. If you fail to connect to the network, check the following, and then retry the ping command. • Make sure that "IPv4" in [Effective Protocol] is set to [Active]. • Check that the machine with assigned IPv4 address is connected to the network. • There is a possibility that the same IPv4 address is used for the specified equipment. Permit SNMPv3 Communication Set the encrypted communication of SNMPv3. Default: [Encryption / Cleartext] If you select to [Encryption Only], you need to set an encryption password for the machine. Permit SSL / TLS Communication Set the encrypted communication of SSL/TLS. Default: [Ciphertext Priority] If you set to [Ciphertext Only], you need to install the SSL certificate for the machine. Host Name Specify the host name. Enter the host name using up to 63 characters. You cannot enter a host name starting or ending with a hyphen. You cannot enter a host name starting with "RNP" or "rnp". Machine Name Specify the machine name. Enter the machine name using up to 31 characters. IEEE 802.1X Authentication for Ethernet Specify the IEEE 802.1X authentication for Ethernet. Default: [Inactive] For details about IEEE 802.1X authentication, see "Configuring IEEE 802.1X". Restore IEEE 802.1X Authentication to Defaults You can return the IEEE 802.1X authentication settings to their defaults. 39