Sony PMW200 User Manual (PMW-100 Memory Camcorder Operation Manual for Firmwar - Page 125
Error/Warning Indications, Error Indications
View all Sony PMW200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Error/Warning Indications The camcorder informs you of situations where warning, caution, or an operation check is required, through messages on the LCD monitor/EVF screen, the tally lamps, and a buzzer. The buzzer is output to the built-in speaker or to the headphones connected via the headphone connector. The buzzer volume can be set with "Alarm Level" in "Audio Output" (page 89) in the AUDIO SET menu. Error Indications The camcorder stops operation after the following indications. Error indication on Buzzer LCD/EVF E + Error code Continuous Tally lamps Rapidly flashing Cause and measures The camcorder may be defective. Recording stops even if zREC is displayed on the LCD monitor/EVF screen. Turn off the power and check the connected equipment, cables, and media. If they are not defective, turn on the power again. If the error persists, consult Sony service personnel. (If power cannot be turned off by setting the power switch to OFF, remove both the battery pack or the DC IN source.) Warning Indications When one of the following indications is generated, follow the message to clear the problem. Warning indication on LCD/EVF Media Near Full Buzzer Intermittent Tally lamps Flashing Media Full Continuous Rapidly flashing Battery Near End Intermittent Flashing Battery End Continuous Rapidly flashing Temperature High Intermittent Flashing Voltage Low Intermittent Flashing Insufficient Voltage Continuous Rapidly flashing HDD A1) Battery Near Intermittent Flashing End HDD A1) Battery End Continuous Rapidly flashing Cause and measures Free space on the SxS memory card has become insufficient. Replace it with another at the earliest opportunity. No space is left on the SxS memory card. Recording, clip copying and clip division cannot be performed. Replace it with another. The battery power will be exhausted soon. Charge the battery pack at the earliest opportunity. The battery pack is exhausted. Recording cannot be performed. Stop operation and change the battery pack. The internal temperature has risen above a safe operation limit. Suspend operation, turn off the power, and wait until the temperature falls. The DC IN voltage has become low (stage 1). Check the power supply. The DC IN voltage is too low (stage 2). Recording cannot be performed. Connect other power source. The battery power of the connected HDD will be exhausted soon. Change the battery at the earliest opportunity. The battery of the connected HDD is exhausted. Recording cannot be performed. Stop operation to change the battery. Appendices Error/Warning Indications 125