D-Link DGS-1510-28P User Manual - Page 183

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide After selecting the UDP option as the Protocol Type, the following section will appear. Figure 8-7 ACL Configuration Wizard (Add Rule for IPv4 ACL) UDP window The dynamic fields that can be configured are described below: Parameter Source Destination Source Port Description Select and enter the source information here. Options to choose from are Any, Host, and IP. When the Any option is selected, any source traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the source host's IP address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the destination information here. Options to choose from are Any, Host, and IP. When the Any option is selected, any destination traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the destination host's IP address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the source port value here. Options to choose from are and Range. When selecting the = option, the specific selected port number will be used. When selecting the > option, all ports greater than the selected port, will be used. When selecting the < option, all ports smaller than the selected port, will be used. When selecting the ≠ option, all ports, excluding the selected port, will be 175