D-Link DGS-1510-28P User Manual - Page 193

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide IP Precedence ToS DSCP Time Range Action address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select the IP precedence value used here. Options to choose from are 0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override), 5 (critical), 6 (internet), and 7 (network). After selecting the IP precedence value, select the Type-of-Service (ToS) value that will be used here. Options to choose from are 0 (normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (maxthroughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15. Select or enter the DSCP value used here. This value must be between 0 and 63. Enter the name of the time range to associate with this ACL rule. Select the action that this rule will take here. Options to choose from are Permit and Deny. After selecting the VRRP option as the Protocol Type, the following section will appear. Figure 8-15 ACL Configuration Wizard (Add Rule for IPv4 ACL) VRRP window The dynamic fields that can be configured are described below: Parameter Fragments Source Description Select the Fragments option to include packet fragment filtering. Select and enter the source information here. Options to choose from are Any, Host, and IP. When the Any option is selected, any source traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the source host's IP address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard 185