Dell PowerConnect W-IAP92 Dell Instant 6.1.2.3-2.0.0.0 User Guide - Page 140

Table 22 Network View-Graphs and Monitoring Procedures (Continued) Graph Name Description Monitoring Procedure Throughput The Throughput graph shows the throughput of the selected network for the last 15 minutes.  Outgoing traffic-Throughput for outgoing traffic is displayed in green. Outgoing traffic is shown above the median line.  Incoming traffic-Throughput for incoming traffic is displayed in blue. Incoming traffic is shown below the median line. To see an enlarged view, click the graph.  The enlarged view provides Last, Minimum, Maximum, and Average statistics for the incoming and outgoing traffic throughput of the network for the last 15 minutes. To see the exact throughput of the selected network at a particular time, hover the cursor over the graph line. To check the throughput of the selected network for the last 15 minutes, 1. Log in to the Instant UI. The Virtual Controller view appears. This is the default view. 2. In the Networks tab, click the network for which you want to check the client association. The Network view appears. 3. Study the Throughput graph in the Usage Trends pane. For example, the graph on the left shows 22.0 kbps incoming traffic throughput for the selected network at 12:03 hours. Instant Access Point View All IAPs in the Dell Instant network are listed in the Access Points tab. Click the IAP that you want to monitor. Access Point view for that IAP appears. Similar to the Virtual Controller view, the Access Point view also has three tabs: Networks, Access Points, and Clients. The following sections in the Instant UI provide information about the selected IAP:  Info  RF Dashboard  RF Trends  Usage Trends Figure 107 Instant Access Point View 140 | Monitoring Dell PowerConnect W-Series Instant Access Point 6.1.2.3-2.0.0.0 | User Guide