Dell PowerEdge R830 Owners Manual - Page 100
Installing a processor
View all Dell PowerEdge R830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Figure 35. Installing a processor 1. socket-release lever 1 3. processor 5. processor shield 7. processor socket 2. pin-1 corner of the processor 4. slot (4) 6. socket-release lever 2 8. tab (4) Next steps NOTE: Ensure that you install the heat sink after you install the processor. The heat sink is necessary to maintain proper thermal conditions. 1. Install the heat sink. 2. If removed, reinstall the PCIe expansion card riser. 3. If disconnected, reconnect the cables to the expansion card(s). 4. Follow the procedure listed in the After working inside your system. 5. While booting, press F2 to enter System Setup and verify that the processor information matches the new system configuration. 6. Run the system diagnostics to verify that the new processor operates correctly. Related references Safety instructions on page 63 Related tasks Before working inside your system on page 64 Removing the cooling shroud on page 76 Removing expansion card risers on page 111 Installing a heat sink on page 101 After working inside your system on page 64 100 Installing and removing system components