Dell PowerEdge R830 Owners Manual - Page 143
Removing a hard drive or a solid state drive from a hard drive carrier, Related tasks, Prerequisites
![]() |
View all Dell PowerEdge R830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Related tasks Removing the optional front bezel on page 65 Installing the optional front bezel on page 66 Removing a 2.5-inch hard drive blank on page 141 Removing a hard drive or a solid state drive from a hard drive carrier Prerequisites 1. Keep the Phillips #1 screwdriver ready. 2. Remove the hot swappable hard drive carrier from the system. Steps 1. Remove the screws from the slide rails on the hard drive carrier. 2. Lift the hard drive out of the hard drive carrier. Figure 75. Removing a hard drive from a hard drive carrier a. screw (4) b. hard drive c. hard drive carrier Next steps If applicable, install a hard drive into the hard drive carrier. Related references Safety instructions on page 63 Related tasks Installing a hard drive or solid state drives into a hard drive carrier on page 143 Installing a hard drive or solid state drives into a hard drive carrier Prerequisites Steps 1. Insert the hard drive into the hard drive carrier with the connector end of the hard drive toward the back of the carrier. 2. Align the screw holes on the hard drive with the screws holes on the hard drive carrier. When aligned correctly, the back of the hard drive is flush with the back of the hard drive carrier. 3. Attach the screws to secure the hard drive to the hard drive carrier. Installing and removing system components 143
![](/manual_guide/products/dell-poweredge-r830-owners-manual-3f71d3b/143.png)