Dell PowerEdge R830 Owners Manual - Page 111
Removing expansion card risers, Table 34. Expansion card installation order, continued
![]() |
View all Dell PowerEdge R830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Table 34. Expansion card installation order (continued) Card Priority Card Type Form Factor Slot Priority Low Profile 3, 4, 5 8 Fibre Channel 8 Gb Single Port Full Height 7, 6, 2 Low Profile 3, 4, 5 9 Fibre Channel 4 Gb Single/ Full Height 7, 6, 2 Dual Port 10 1 Gb NICs Low Profile 3, 4 Full Height 7, 6, 2 11 External Non-RAID Controller Full Height 7, 6, 2, 1 12 NVMe PCIe SSD card Full Height 7, 6, 2, 1 Full Height (Low 7, 6, 2, 1 (3 ,4) Profile) Full Height , Half 6, 1, 2, 7 Length 13 Mellanox ConnectX-4 Full Height 6, 1 Max Allowed 2 3 3 3 2 3 3 2 4 4 2 Removing expansion card risers Prerequisites CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product. 1. Follow the safety guidelines listed in the Safety instructions section. 2. Follow the procedure listed in the Before working inside your system section. Steps 1. Holding the slots on the expansion card riser, lift the riser from the riser connector on the system board. 2. To remove expansion card riser 3, hold the edges of the expansion card riser. NOTE: To ensure proper system cooling, the riser blank must be installed in the appropriate riser slot. Remove the riser blank only if you are installing a riser. Installing and removing system components 111
![](/manual_guide/products/dell-poweredge-r830-owners-manual-3f71d3b/111.png)