Dell PowerEdge R830 Owners Manual - Page 134
Removing the NDC
View all Dell PowerEdge R830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product. Steps 1. Loosen the captive screws that secure the network daughter card (NDC) to the system board. 2. Hold the NDC by the edges on either side of the touch point, and lift the card to disengage it from the connector on the system board. 3. Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in the back panel. 4. Lift the NDC out of the chassis. Figure 65. Removing the NDC 1. captive screw socket (2) 3. captive screw (2) 5. network daughter card (NDC) 2. connector on the system board 4. touch point (2) 6. back panel slot for Ethernet connectors Next steps 1. Install the NDC. 2. If removed, install the expansion card riser 1. 3. Follow the procedure listed in the After working inside your system section. Related references Safety instructions on page 63 Related tasks Before working inside your system on page 64 Removing an expansion card from expansion card riser 1 on page 118 134 Installing and removing system components