Dell PowerEdge R830 Owners Manual - Page 122
Dell PowerEdge R830 Manual
![]() |
View all Dell PowerEdge R830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product. 1. Follow the safety guidelines listed in the Safety instructions section. 2. Follow the procedure listed in the Before working inside your system section. 3. Holding the touch points on the riser, lift the expansion-card riser out of the chassis. Steps 1. Disconnect any cables connected to the expansion card. 2. Press the expansion card retention latch and pull it open from the expansion card riser. NOTE: For a full-height expansion card, pull the expansion card holder away from the expansion card riser. 3. Hold the expansion card by its edges, and remove it from the expansion card connector. 4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion card latch. NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper thermal conditions. 5. Close the expansion card riser latch into the slot. Figure 55. Removing an expansion card from expansion card riser 2 1. expansion card riser 2 3. touch point (2) 5. expansion card 2. expansion card connector 4. expansion card latch Next steps 1. Install the expansion card riser 2. 122 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r830-owners-manual-3f71d3b/122.png)