Dell PowerEdge R830 Owners Manual - Page 40
Viewing Network Settings, Network Settings screen details, UEFI iSCSI Settings
![]() |
View all Dell PowerEdge R830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Related tasks Viewing Network Settings on page 40 Viewing UEFI iSCSI Settings on page 41 Viewing Network Settings To view the Network Settings screen, perform the following steps: Steps 1. Turn on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again. 3. On the System Setup Main Menu screen, click System BIOS. 4. On the System BIOS screen, click Network Settings. Related references Network Settings on page 39 Network Settings screen details on page 40 Network Settings screen details The Network Settings screen details are explained as follows: About this task Option Description PXE Device n (n Enables or disables the device. When enabled, a UEFI boot option is created for the device. = 1 to 4) PXE Device n Enables you to control the configuration of the PXE device. Settings(n = 1 to 4) Related references Network Settings on page 39 Related tasks Viewing Network Settings on page 40 UEFI iSCSI Settings You can use the iSCSI Settings screen to modify iSCSI device settings. The iSCSI Settings option is available only in the UEFI boot mode. BIOS does not control network settings in the BIOS boot mode. For the BIOS boot mode, the option ROM of the network controller handles the network settings. Related references UEFI iSCSI Settings details on page 41 40 Pre-operating system management applications
![](/manual_guide/products/dell-poweredge-r830-owners-manual-3f71d3b/40.png)