Epson 9600 Service Manual - Page 153
Stylus Pro 7600/9600 uses many FFCs Flexible Flat Cables.
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
EPSON Stylus Pro 7600/9600 Revision A W A R N IN G Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacture. Dispose the used batteries according to government's law and regulations. Wear protective goggles to protect your eyes from ink. If ink gets in your eye, flush the eye with fresh water and see a doctor immediately. Wear a pair of gloves to protect your hands from the sharp edge in the printer mechanism. If ink comes into contact with your skin, wash it off with soap and water. If irritation occurs, contact a physician. W A R N IN G Avant de commencer, assurez vous que l'imprimante soit eteinte et que le cordon d'alimentation soit debranche. Lorsque vous changez la pile au lithium, assurez vous que la nouvelle respecte bien les caracteristiques requises. Lorque que vous installez la pile au lithium, faites attention a l'inserer dans le bon sens en respectant la polarite. Veillez a jeter les piles usagees selon le reglement local. Ne rechargez pas les piles au lithium. C A U T IO N Risque d'explosion si la pile est remplacée incorrectment. Ne remplacer que par une pile du même type ou d'un type équivalent recommandé par le fabricant. Eliminer les piles déchargées selon les lois et les règles de sécurité en vigueur. C A U T IO N Before servicing or performing maintenance on the printer, make sure you have enough space. If you need to move the printer, make sure the space you move to is safe. Because the printer is much heavier than most printers you need to take extra care. If you need to take apart the printer and the stand from each other or put then together, two people are necessary. If you remove and replace any parts of the ink path system, be sure to discharge the ink beforehand by executing "Ink Blowing" in "Clean Head" process. Refer to "5.2.3.20 Clean Head (p.256)". After removing any of the ink related parts, double check to make sure all parts are secured; otherwise you're going to be in big trouble. Use only recommended tools for disassembling, assembling or adjusting the printer. Apply lubricants and adhesives as specified. Ink may leak onto other printer parts or the printer basket when removing printer parts, so it is recommended to put a sheet or cloth under the printer, especially when working on or near ink-related parts. When working on the electrical circuit boards, be careful concerning static electricity which can cause damage to the board. It is recommended you use an anti-static wrist band or similar grounding device to prevent static electricity buildup. Stylus Pro 7600/9600 uses many FFCs (Flexible Flat Cables). Improper connection, such as slanting insertion, of an FFC can cause a short circuit resulting in broken elements on the circuit board. Be sure to connect the FFCs to the connectors properly with great care. Disassembly & Assembly Summary 153