Epson 9600 Service Manual - Page 266
Adjustment, Mechanism Adjustment
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 266 highlights
EPSON Stylus Pro 7600/9600 8. Set the 0.9-mm thickness gauge between the PF Grid Roller and the Driven Roller near the detection arm on the paper transport path, and bring down the Paper Set Lever toward you (to the "paper holding" position). At this point, if the value on the LCD is not "11", loosen the screw securing the mounting plate for the P_THICK Sensor (right). Then slide the mounting plate to a position where the LCD shows "11", tighten the screw and remove the 0.9-mm thickness gauge. 9. Set the 0.8-mm thickness gauge the same way as above and make certain that the value on the LCD is "01". At this point, if the value on the LCD is not "01", loosen the screw securing the mounting plate for the P_THICK Sensor (right). Then slide the mounting plate to a position where the LCD shows "01", tighten the screw and check the previous step again. 10. Turn the power switch Off, then after disconnecting the power cable, install the H Top Cover. Mounting Plate P_THICK_0.3 Sensor Mounting Plate (left) P_THICK Sensor Mounting Plate (right) - Table 5-30. Gauge Condition 0.3 mm 0.4 mm 0.8 mm 0.9 mm Paper thickness 0.3 mm or below Paper thickness 0.4 ∼ 0.6 mm Paper thickness 0.7mm or above Lever in "Up" position (Paper released) Lever in "Down" position (Paper held) LCD Indication 00 01 11 10 00 C A U T I O N Take care not to bend thickness gauges by, say, dropping. This adjustment requires an accuracy to units of 0.1 mm. Adjustment Mechanism Adjustment Revision A 266