Epson 9600 Service Manual - Page 239
Feed Correction + T&B Adjustment
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 239 highlights
EPSON Stylus Pro 7600/9600 5.2.3.7 Feed Correction + T&B Adjustment For paper transport, correct the distance and adjust the top & bottom margins and side margin (printing start position). (See page 241) Feed Adjustment (Paper feed distance compensation): Make the printer print a line in the paper feed direction, input the distance and determine the PF encoder resolution inside the firmware. The reference length for this determination has been set to 1 m. (Only the input of a compensation value without printing is possible.) The input value, handled as the compensation value, is written in the Flash ROM. Resolution: 0.1mm Adj Top & Bottom: Conduct printing and paper cutting and input the distances between the Front Sensor and the Head, between the Cutter and the Head and between the Edge Sensor and the Head (writing start position). The input value, handled as the compensation value, is written in the Flash ROM. Resolution: 0.1mm Side Margin Adjustment (Print Start Position Adjustment): Conduct printing and paper cutting, then measure and input the side margin. The input value, handled as the compensation value, is written in the Flash ROM. Adjustment resolution: 0.1mm Menu transition is shown at right and adjustment patterns are shown on the next page. Press the [Pause] key on the compensation value input screen, and the display will change to "Feed Adj.+T&B". Press the [Pause] key on the "Top Length" or "Bottom Length" input screen, and the display will change to the "Bottom Length" or "Side Margin" input screen, respectively. "Top Length", "Bottom Length" and "Side Margin" can be adjusted only in the T&B adjustment mode for the first printing. Revision A T&B Adjust? [Enter] [Enter] Adjust Print Enter:Adjust Pause:Do not adjust [Pause] [Enter] Printing Pattern Adjust [Paper Feed ∆]Key: + [Paper Feed ∇]Key : - * Setting is possible in increments of 0.1 mm. Do not adjust. Or 2nd or subsequent printing Top Length : ? 3.0mm [SelecType] [Paper Feed ∆]Key: + [Paper Feed ∇]Key : - * Setting is possible in increments of 0.1 mm. Bottom Length : ? 14.0mm [SelecType] [Paper Feed ∆]Key: + [Paper Feed ∇]Key : - * Setting is possible in increments of 0.1 mm. Side Margin: ? 3.0mm [SelecType] V Length : ? +1000.0mm [Paper Feed ∆]Key: + [Paper Feed ∇]Key : - * Setting is possible in increments of 0.1 mm. [Paper Feed ∆]Key: + [Paper Feed ∇]Key : - * Setting is possible in increments of 0.1 mm. [SelecType] [Enter] [Enter] Adjust Print [Pause] Key →To "Rear Sensor Pos." [Enter] Figure 5-32. Menu Transition for Feed Correction +T&B Adjustment Adjustment Self-diagnostic Function 239