Epson 9600 Service Manual - Page 51

EPSON Stylus Pro 7600/9600 1.4.3.27 Consumables life † Cutter life „ How to calculate The number of times the cutter has been used is calculated by counting down from 2000. The count is reduced by one every time one sheet is cut irrespective of paper sizes. The counter is cleared at replacing the cutter with a new one. „ Display (Life) 100 ~ 81% E F 80 ~ 61% E F 60 ~ 41% E∗∗∗ F 40 ~ 21% E∗∗ F 20% ~ 1% E∗ F Less than 1% remaining FF „ Maintenance Req. Not happen, because • Cutter condition can be checked with cutting. • It doesn' t cause big obstacles. • Users can replace a cutter easily. „ Fatal error Not happen. „ Counter clear The counter is cleared at replacing the cutter with a new one. CHECK P O IN T The indication as described above may not be accurate depending on the conditions of use, thus it is given only as a yardstick. Revision A † CR motor life monitor „ How to calculate It is displayed with tube life (B1 width), because tube friction causes CR motor trouble. The tube life is calculated with the number of CR scan times. Printer Model Stylus Pro 7600 Stylus Pro 9600 Table 1-36. Reference value Number of Passes Condition 250 million passes B0/ Speed 325 million passes A1/ Speed Note : 1 pass = 1 round trip „ Display (Life) 100 ~ 81% 80 ~ 61% 60 ~ 41% 40 ~ 21% 20% ~ 1% Less than 1% remaining E F E F E∗∗∗ F E∗∗ F E∗ F FF „ Maintenance Req. It is happened when the life is less than 4%. „ Fatal error When the remainder of the life is judged to be 0 by taking into account damage to the tube, service call occurs. „ Counter clear When "CLEAR COUNTERS CR MOTOR" or "CLEAR COUNTERS CR TOTAL" in Maintenance mode 2 is executed, the counter is cleared. CHECK P O IN T Information on these values is needed only when service personnel perform maintenance work. Do not inform users of the meaning of these indications. Product Description Operating Panel 51