Epson 9600 Service Manual - Page 194
Disassembly & Assembly, Disassembly and Assembly of Ink Supply Mechanism
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
EPSON Stylus Pro 7600/9600 9. Remove one screw (CUPS: M3×6) and one screw (CUPS: M4×6) securing the I/H Frame on the left side. (See Figure 4-65) 10. Remove seven screws (CUPS: M3×6) and two screws (CUPS: M4×6) securing the I/H Frame on the top. 11. Lift the I/H Frame and disconnect the connector of the Release Sensor (I/H Lever). (See Figure 4-66) 12. Remove the I/H Frame while paying attention to the connectors of the Cover Sensor and Release Sensor (I/H Lever). Before installing the I/H Frame, make certain that the gear of the I/H Lever is engaged with the gear of the Cartridge Lock Shaft and also that the Cover Sensor turns ON and OFF. Check gear engagement Revision A Screws (CUPS: M3×6) ×7 Screws (CUPS: M4×6) ×2 Screw (CUPS: M4×6) Screw (CUPS: M3×6) ×7 Figure 4-65. I/H Frame Removal 2/2 Check Release Sensor ON/OFF When installing the I/H Frame, make sure that the projections on the I/H ASSY are fitted in the seven holes in the top plate properly. If the I/H ASSY is not installed properly, the ink cartridges may not be recognized. Connector of Release ASSY Figure 4-66. Release Sensor (I/H Lever) Removal Disassembly & Assembly Disassembly and Assembly of Ink Supply Mechanism 194