Epson 9600 Service Manual - Page 241
Print Pattern for Feed Correction + T&B Adjustment
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 241 highlights
EPSON Stylus Pro 7600/9600 FEED CORRECTION + T&B ADJUSTMENT 1. Start the Self-diagnostic Function: Power OFF → [Paper Feed ∆]+[Paper Feed ∇]+[Cut/Eject] → Power ON 2. Display "Adj: Feed Adj.+T&B": [Paper Feed ∇] → [SelecType >] → [Paper Feed ∆] x6 3. Print the pattern. [SelecType >] →[Enter ↵] when "[Enter] Adjust Print" is displayed (See Figure 5-32) 4. Measure the top margin: Using a measuring rule, measure the top margin. Input the measured value on the panel. 5. Measure the bottom margin: Using a measuring rule, measure the bottom margin. Input the measured value on the panel. 6. Measure the side margin: Using a measuring rule, measure the side margin. Input the measured value on the panel. 7. Measure the feed correction value: Using a measuring rule (1000 mm) and the scale stopper, measure the longitudinal line length. Input the measured value on the panel. CHECK P O IN T The central print pattern among the patterns as shown above is intended for use as a datum line on which the measuring rule is to be placed. Even if you have left the "Feed Correction + T&B Adjustment" mode by mistake, you can restore the relevant adjustment display without reprinting the pattern, by pressing [Paper Source