Epson 9600 Service Manual - Page 267
Cover Sensor ASSY Mounting Position Adjustment
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
EPSON Stylus Pro 7600/9600 5.3.5 Cover Sensor ASSY Mounting Position Adjustment When removing/replacing the Cover Assembly or the Front Cover, verify the sensor operation using the Self-Diagnostic mode as described below. NOTE: For disassembly and assembly procedure, refer to "Cover Sensor ASSY" (p.197). 1. Remove the Tube cover. See "Cover Sensor ASSY" (p.197). 2. Start the Self-diagnostic Function: Power OFF → [Paper Feed ∆]+[Paper Feed ∇]+[Cut/Eject] → Power ON 3. Display "Test: Sensor": [SelecType >] → [Paper Feed ∇] x2 4. Display "Sen: Cover": [SelecType >] → [Paper Feed ∇] x1 5. Open and close the Front Cover, checking the LCD to make sure the message changes depending on the Front Cover position. Table 5-31. Cover Sensor Assembly Check Front Cover LCD Message Open Sen: Cover Open Close Sen: Cover Close 6. If the correct message does not appear or any other message appears, verify the Cover Sensor is installed correctly and check the operation again. CHECK P O IN T Acceptance Criterion: The timing for cover opening is such that there is no gap between the front cover and the printer body which permits entrance of your finger. Revision A Cover Sensor ASSY Figure 5-68. Adjusting the Cover Sensor ASSY Mounting Position Adjustment Mechanism Adjustment 267