Epson 9600 Service Manual - Page 269
Cutter Holder ASSY height adjustment.
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 269 highlights
EPSON Stylus Pro 7600/9600 5.3.7 Cutter Positioning Adjustment This adjustment should definitely be mad if the following parts are removed. Parts Cutter Solenoid Assy Paper Guide L Adjustment Items 1. Paper Guide L up and down adjustment 2. Cutter Holder ASSY height adjustment 1. Paper Guide L up and down adjustment This adjustment is intended to install the cutter at a proper position and height relative to the step for the cutter on the Paper Guide L. The number of adjustment items required depends on the parts replaced. Carry out work by referring to the table above. Adjusting tools: Cutter positioning jig #F800 NOTE: For disassembly and assembly procedure, refer to "Cutter Holder ASSY (p.175)". CHECK P O IN T For adjustments at replacing the Cover Sensor ASSY, make the Paper Guide L up and down adjustment first and then make the Cutter Holder ASSY height adjustment. 1. Remove the H Top Cover. (p.165) NOTE: For Stylus Pro 9600, remove also the H Top Cover (p.165) and the Tube Cover (p.193). 2. Open the Front Cover, and remove the cutter. 3. Return the CR Unit to the cap position and set the cutter positioning tool at the right end of the Paper Guide L. (See Figure 5-73) 4. Loosen the screws securing the Paper Guide L. NOTE: 3 screws for Stylus Pro 7600 / 5 screws for Stylus Pro 9600 CHECK P O IN T To loosen the screw at the left end of the Paper Guide L, pass the screwdriver through the cut portion of the I/H Frame Top Plate. (See Figure 5-72) Revision A Cutter Holder ASSY height adjustment Paper Guide L up and down adjustment Figure 5-71. Cutter Positioning Adjustment Cut portion of I/H Frame Figure 5-72. Removing the screw for Paper Guide L (at left end) Adjustment Mechanism Adjustment 269