Epson 9600 Service Manual - Page 171
Disassembly and Assembly of Carriage CR, Mechanism
UPC - 010343841888
View all Epson 9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
EPSON Stylus Pro 7600/9600 4.3 Disassembly and Assembly of Carriage (CR) Mechanism 4.3.1 Print Head C A U T IO N When unlocking the carriage, do not move the carriage by about 2 cm or more with the cutter pushed into the innermost position; otherwise, the cutter edge would be damaged. CHECK P O IN T When replacing the print head with a new one, execute ink discharge ("Ink Blowing" on page 256) beforehand. 1. Execute ink discharge operation to discharge the ink from all the ink passages. 2. While pushing the cutter area gently, shift the carriage to the left about 2 cm to unlock the carriage and then move the carriage to the printer center. (See Figure 4-24) 3. Loosen the one screw (CP(W): M3×6) securing the front end of the damper holder and separate the Damper Unit from the print head. (See Figure 4-25) CHECK P O IN T When removing the head, hang the hook of the Damper Unit in the hole of the bottom plate of the CR Board Assy so that work will not be obstructed by the Damper Unit. In addition, for easier work, you are advised to lift with Scotch tape to such a degree that no significant load is applied to the ink tubes. There is a hook 2 cm high at the center of the head. Install the Damper Unit with care not to hit it against the hook. When installing the Damper Unit, before tightening the screw, press the lower area of the Damper with your fingers so that it comes in close contact with the print head. Revision A Push Move the carriage Cutter area Figure 4-24. Carriage Lock Release Loosen the screw (CP(W): M3×6) Damper Unit Figure 4-25. Damper Holder Loosening Disassembly & Assembly Disassembly and Assembly of Carriage (CR) Mechanism 171