HP Workstation x1000 hp workstations general - adaptec RAID installation guide - Page 32

to High Only.

Get HP Workstation x1000 PDF manuals and user guides View all HP Workstation x1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Adaptec RAID Installation Guide cables where one cable is Narrow, set the controller termination to High Only. The following figure shows various SCSI cabling examples. Terminate your SCSI devices as shown in the examples, ensuring that the devices at the ends of the cables are terminated and the devices in the middle are not terminated. If only one cable is attached, then one end is the controller, and must have its termination enabled, as indicated in the diagrams where the circled T is in the controller. Note: SCSI only-Each channel being used on a multi-channel RAID adapter must be terminated properly for its configuration. 2-6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
2-6
Adaptec RAID Installation Guide
cables where one cable is Narrow, set the controller termination
to High Only.
The following figure shows various SCSI cabling examples.
Terminate your SCSI devices as shown in the examples, ensuring
that the devices at the ends of the cables are terminated and the
devices in the middle are not terminated. If only one cable is
attached, then one end is the controller, and must have its
termination enabled, as indicated in the diagrams where the
circled T is in the controller.
Note:
SCSI only
—
Each channel being used on a multi-channel
RAID adapter must be terminated properly for its
configuration
.