IBM 8669 Hardware Maintenance Manual - Page 112
Host Built-In Self Test (BIST), Bus fault messages, Undetermined problems, Message, Action, Host fail
UPC - 087944636496
View all IBM 8669 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Host Built-In Self Test (BIST) Message Host fail (level-informational; host's built-in self test failed) Action 1. Reseat CPU 2. Reseat VRM 3. Replace CPU Bus fault messages Bus fault messages Failure reading 12C device. Check devices on bus 0. Failure reading 12C device. Check devices on bus 1. Failure reading 12C device. Check devices on bus 2. Failure reading 12C device. Check devices on bus 3. Failure reading I2C device. Check device on bus 4. Message Action 1. If installed, reseat I2C cable between Remote Supervisor Adapter (in PCI slot 1/J44) and planar (J45) 2. Reseat Memory DIMMs 3. Memory DIMMs 4. System board 1. Reseat I2C cable between operator information panel and planar (J39) 2. Replace Operator information panel 3. System board 1. Reseat cable between Power Backplane and planar (J43) 2. Reseat Power Backplane 3. Reseat Power Supply 4. Replace Power Backplane 5. Replace Power Supply 6. Replace System board 1. Reseat Cable (Signal I2C - IO Planar to SCSI Backplane) between DASD backplane and connector (J9) of planar 2. Replace DASD backplane 3. Replace System board 1. System board Undetermined problems You are here because the diagnostic tests did not identify the failure, the Devices List is incorrect, or the system is inoperative. Note: A corrupt CMOS can cause undetermined problems. Note: A corrupt BIOS can cause undetermined problems. (See "Recovering BIOS code" on page 16.) Check the LEDs on all the power supplies, see "Power supply LED errors" on page 92. If the LEDs indicate the power supplies are working correctly, return here and do the following: 1. Power-off the computer. 2. Be sure the system is cabled correctly. 102 Hardware Maintenance Manual: xSeries 342 Type 8669