IBM 8669 Hardware Maintenance Manual - Page 52
Locations, Removing the cover and bezel, Statement 1
UPC - 087944636496
View all IBM 8669 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
v Always handle components carefully. Handle adapters, the memory board, and memory modules (DIMMs) by the edges. Never touch any exposed circuitry. v Prevent others from touching components. v When you are installing a new option, touch the static-protective package containing the option to a metal expansion-slot screw or other unpainted metal surface on the server for at least two seconds. (This reduces static electricity from the package and from your body.) v When possible, remove the option and install it directly into the server without setting the option down. When this is not possible, place the static-protective package that the option comes in on a smooth, level surface and place the option on it. v Do not place the option on the server's covers or any metal surface. Locations The following sections describe how to remove and/or install certain components inside the server. Removing the cover and bezel The following section describes how to remove the cover and bezel. Cover-release latch Side latch Bezel Side latch To remove the server top cover: 1. Review the information in "Before you begin" on page 40. 2. If you are planning to install or remove any part other than a hot-swap hard disk drive, hot-swap power supply, or hot-swap fan, turn off the server and all attached devices and disconnect all external cables and power cords. Statement 1: 42 Hardware Maintenance Manual: xSeries 342 Type 8669