Lantronix SLB Lantronix SLB - User Guide - Page 103
Device Port Commands, Apply, Sensorsoft Status, Parameters
View all Lantronix SLB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Figure 8-7 Devices > Device Ports > Sensorsoft 8: Device Ports 3. Select a port and enter or view the following information: Dev Port Device Port Name Temp Low Temp High Temp Use °F Humidity (%) Low Humidity High Humidity Traps Displays the number of the SLB port. Displays the name of the SLB port. Current temperature (degrees Celsius) on the device the sensor is monitoring. Enter the temperature (degrees Celsius) permitted on the monitored device below which the SLB sends a trap. Enter the temperature (degrees Celsius) permitted on the monitored device above which the SLB sends a trap. Display and set the temperature for this device in degrees Fahrenheit, instead of Celsius, which is the default. Current relative humidity on the device the sensor is monitoring. Enter the relative humidity permitted on the device the sensor is monitoring below which the sensor sends a trap to the SLB. Enter the highest relative acceptable humidity permitted on the device above which the sensor sends a trap to the SLB. Select to indicate the SLB should send a trap or configured Event Alert when the sensor detects an out-of-range configured threshold. 4. Click the Apply button. 5. To view the status detected by the Sensorsoft, click the Sensorsoft Status link to the right of the table. Device Port Commands The following CLI commands correspond to the web page entries described above. To configure a single port or a group of ports (for example, set deviceport port 2-5,6,12,1516 baud 2400): set deviceport port Parameters: auth banner SLB - Branch Office Manager User Guide 103