Lantronix SLB Lantronix SLB - User Guide - Page 56

6: Basic Parameters DNS Servers DNS Servers #1 - #3 Configure up to three name servers. #1 is required if you choose to configure DNS (Domain Name Server) servers. The first three DNS servers acquired via DHCP through Eth1 and/or Eth2 display automatically. DHCP-Acquired DNS Servers #1 - #3 Displays the IP address of the name servers if automatically assigned by DHCP. GPRS-Acquired DNS Servers #1 - #3 Displays the IP address of the name servers if automatically assigned by General Packet Radio Service (GPRS). TCP Keepalive Parameters Start Probes Number of seconds the SLB waits after the last transmission before sending the first probe to determine whether a TCP session is still alive. The default is 600 seconds (10 minutes). Number of Probes Number of probes the SLB sends before closing a session. The default is 5. Interval The number of seconds the SLB waits between probes. The default is 60 seconds. 3. To save your entries, click the Apply button. Apply makes the changes immediately and saves them so they will be there when the SLB is rebooted. Ethernet Counters The Network > Network Settings page displays statistics for each of the SLB's Ethernet ports since boot-up. The system automatically updates them. Note: For Ethernet statistics for a smaller time period, use the diag perfstat command. Network Commands The following CLI commands correspond to the web page entries described above. To configure Ethernet port 1 or 2: set network port Parameters: mode state [ipaddr mask ] [ipv6addr ] To configure up to three DNS servers: set network dns ipaddr SLB - Branch Office Manager User Guide 56