Lantronix SLB Lantronix SLB - User Guide - Page 116
Power Outlet Commands, Apply, Parameters, Example
View all Lantronix SLB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
8: Device Ports 2. Enter the following: Switching Delay Over Current Alarm Current Level for all Outlets Number of milliseconds the SLB between subsequent switching. The range is 1000-2500 msec. The default is 2000 msec (2 sec). If SNMP traps are enabled (see Chapter 7: Services on page 68), a trap (alarm) is sent if the total current for all outlets exceeds a threshold. Enter the number of amps (measured in tenths of an amp) above which the SLB sends a trap. The maximum is 180. Note: If the alarm goes off, a warning message displays on the CLI. Displays the total load carried by the outlets. 3. View or enter the following information for each outlet: Outlet Displays the number of the outlet being configured. Status Displays the current state of the outlet. Name User-configurable name identifying the outlet. Description (optional) User-configurable text describing the outlet. Current Displays the load, in Amps, for the outlet. Power State Select whether the power should be on or off. Default is Off. Wakeup Mode Select whether, after a reboot, the power state for the outlet should be on, off, or returned to the state it was in before the reboot. Default is Off. Last State Select whether to return the outlet to the state it was in before the reboot. Reboot To power cycle the outlet, select the checkbox. Default is unchecked. Note: You can reboot the SLB on the Maintenance > Firmware & Config page, but after the reboot, the power outlet has the same power state as it did before the reboot. 4. To save, click Apply. Power Outlet Commands The following CLI commands correspond to the web page entries described above. To configure and control power outlets: set power switchingdelay set power alarmthreshold set power outlet Parameters: name description state wakeup reboot Example: set power outlet 1-2,4 state on SLB - Branch Office Manager User Guide 116