Lantronix SLB Lantronix SLB - User Guide - Page 62

6: Basic Parameters Updating an IP Filter To update an IP filter rule set: 1. From the Network > IP Filter page, the administrator selects the IP filter ruleset to be edited and clicks the Edit Ruleset button to return to the Network > IP Filter Ruleset (Adding/Editing Rulesets) page (see Figure 6-3). 2. Edit the information as desired and click the Apply button. Deleting an IP Filter To delete an IP filter rule set: 1. On the Network > IP Filter page, the administrator selects the IP filter ruleset to be deleted and clicks the Delete Ruleset button. Mapping a Ruleset The administrator can assign an IP Filter Ruleset to a network interface (Ethernet interface) and a modem connected to a Device Port. To map a rule set to a network interface: 1. On the Network > IP Filter page, select the IP filter ruleset to be mapped. 2. From the Interface drop-down list, select the interface and click the Map Ruleset button. The Interface and rule set display in the IP Filter Mappings table. To delete a mapping: 1) On the Network > IP Filter page, select the mapping from the list and click the Delete Mapping button. The mapping no longer displays. 2) Click the Apply button. IP Filter Commands The following CLI commands correspond to the web page entries described above. To enable or disable IP filtering for incoming network traffic: set ipfilter state To set IP filter mapping: set ipfilter mapping Parameters: ethernet state ethernet state ruleset deviceport state deviceport state ruleset SLB - Branch Office Manager User Guide 62