Lexmark CX317 User Guide - Page 170
Configuration change, some held jobs were not restored [57], Defective flash detected [51]
View all Lexmark CX317 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Troubleshooting 170 Configuration change, some held jobs were not restored [57] Held jobs are invalidated because of any of the following possible changes in the printer: • The printer firmware has been updated. • The tray for the print job is removed. • The print job is sent from a flash drive that is no longer attached to the USB port. • The printer hard disk contains print jobs that were stored when the hard disk was installed in a different printer model. Note: The printer hard disk and the flash drive are supported only in select printer models. From the printer control panel, select Continue to clear the message. For non-touch-screen printer models, press to confirm. Defective flash detected [51] Try one or more of the following: • Replace the defective flash memory card. • From the printer control panel, select Continue to ignore the message and continue printing. For non‑touch‑screen printer models, press • Cancel the current print job. to confirm. Error reading USB drive. Remove USB. An unsupported USB device is inserted. Remove the USB device, and then insert a supported one. Error reading USB hub. Remove hub. An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one. Incompatible tray [x] [59] Remove, and then reinstall the indicated tray to clear the message. Incorrect paper size, open [paper source] [34] Note: The paper source can be a tray or a feeder. Try one or more of the following: • Load the correct size of paper in the paper source. • From the printer control panel, select Continue to clear the message and print using a different paper source. For non‑touch‑screen printer models, press to confirm. • Check the length and width guides of the paper source and make sure the paper is loaded properly. • Make sure the correct paper size and type are specified in the Printing Preferences or in the Print dialog. • Make sure the paper size and type are specified in the Paper menu on the printer control panel.