Netgear M4100-50G CLI Manual - Page 122

ProSafe M4100 and M7100 Managed Switches no monitor session Use this command without optional parameters to remove the monitor session (port monitoring) designation from the source probe port, the destination monitored port and all VLANs. Once the port is removed from the VLAN, you must manually add the port to any desired VLANs. Use the source interface parameter or destination interface to remove the specified interface from the port monitoring session. Use the mode parameter to disable the administrative mode of the session Note: Since the current version of 7000 series software supports only one session, if you do not supply optional parameters, the behavior of this command is similar to the behavior of the no monitor command. Format Mode no monitor session [{source interface | destination interface | mode}] Global Config no monitor This command removes all the source ports and a destination port for the and restores the default value for mirroring session mode for all the configured sessions. Note: This is a stand-alone "no" command. This command does not have a "normal" form. Default Format Mode enabled no monitor Global Config show monitor session This command displays the Port monitoring information for a particular mirroring session. Note: The parameter is an integer value used to identify the session. In the current version of the software, the parameter is always one (1) Switching Commands 122