Netgear M4100-50G CLI Manual - Page 458
match ip precedence, match ip tos, The IP DSCP, IP Precedence, and IP ToS match conditions are
![]() |
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 458 highlights
ProSafe M4100 and M7100 Managed Switches match ip precedence This command adds to the specified class definition a match condition based on the value of the IP Precedence field in a packet, which is defined as the high-order three bits of the Service Type octet in the IP header (the low-order five bits are not checked). The precedence value is an integer from 0 to 7. Note: The IP DSCP, IP Precedence, and IP ToS match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Default Format Mode none match ip precedence Class-Map Config match ip tos This command adds to the specified class definition a match condition based on the value of the IP TOS field in a packet, which is defined as all eight bits of the Service Type octet in the IP header. The value of is a two-digit hexadecimal number from 00 to ff. The value of is a two-digit hexadecimal number from 00 to ff. The denotes the bit positions in that are used for comparison against the IP TOS field in a packet. For example, to check for an IP TOS value having bits 7 and 5 set and bit 1 clear, where bit 7 is most significant, use a value of a0 (hex) and a of a2 (hex). Note: The IP DSCP, IP Precedence, and IP ToS match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Note: This "free form" version of the IP DSCP/Precedence/TOS match specification gives the user complete control when specifying which bits of the IP Service Type field are checked. Default none Quality of Service (QoS) Commands 458
![](/manual_guide/products/netgear-m4100d10poe-cli-manual-76e4515/458.png)