Netgear M4100-50G CLI Manual - Page 290
Default Passive, Metric Type
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 290 highlights
ProSafe M4100 and M7100 Managed Switches Term Definition Default Passive Setting Shows whether the interfaces are passive by default. Default Route Advertise Indicates whether the default routes received from other source protocols are advertised or not. Always Shows whether default routes are always advertised. Metric The metric of the routes being redistributed. If the metric is not configured, this field is blank. Metric Type Shows whether the routes are External Type 1 or External Type 2. Number of Active Areas The number of active OSPF areas. An "active" OSPF area is an area with at least one interface up. AutoCost Ref Shows the value of auto-cost reference bandwidth configured on the router. BW Maximum Paths The maximum number of paths that OSPF can report for a given destination. Redistributing This field is a heading and appears only if you configure the system to take routes learned from a non-OSPF source and advertise them to its peers. Source The source protocol/routes that are being redistributed. Possible values are static, connected, or RIP. Tag The decimal value attached to each external route. Subnets For redistributing routes into OSPF, the scope of redistribution for the specified protocol. Distribute-List The access list used to filter redistributed routes. The following shows example CLI display output for the command. (Switch) #show ip ospf Router ID 2.2.2.2 OSPF Admin Mode Disable RFC 1583 Compatibility Enable External LSDB Limit No Limit Exit Overflow Interval 0 Spf Delay Time 5 Spf Hold Time 10 Opaque Capability Disable AutoCost Ref BW 100 Mbps Default Passive Setting Disabled Maximum Paths 4 Default Metric Not configured Default Route Advertise Disabled Always FALSE Metric Not configured Metric Type External Type 2 Routing Commands 290