Netgear M4100-50G CLI Manual - Page 517
System Information and Statistics Commands, update bootcode, show arp switch, show eventlog
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 517 highlights
ProSafe M4100 and M7100 Managed Switches update bootcode This command updates the bootcode (boot loader) on the switch. The bootcode is read from the active-image for subsequent reboots. The optional parameter is valid only on Stacks. Error will be returned, if this parameter is provided, on Standalone systems. For Stacking, the parameter identifies the node on which this command must be executed. When this parameter is not supplied, the command is executed on all nodes in a Stack. Format Mode update bootcode [] Privileged EXEC System Information and Statistics Commands This section describes the commands you use to view information about system features, components, and configurations. show arp switch This command displays the contents of the IP stack's Address Resolution Protocol (ARP) table. The IP stack only learns ARP entries associated with the management interfaces network or service ports. ARP entries associated with routing interfaces are not listed. Format Mode show arp switch Privileged EXEC Term IP Address MAC Address Interface Definition IP address of the management interface or another device on the management network. Hardware MAC address of that device. For a service port the output is Management. For a network port, the output is the slot/port of the physical interface. show eventlog This command displays the event log, which contains error messages from the system. The event log is not cleared on a system reset. The is the switch identifier. Format Mode show eventlog [] Privileged EXEC Term File Line Definition The file in which the event originated. The line number of the event. Utility Commands 517