Netgear M4100-50G CLI Manual - Page 227
IP Routing Commands, show arp switch, routing
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 227 highlights
ProSafe M4100 and M7100 Managed Switches Term Definition Age Time (seconds) The time it takes for an ARP entry to age out. This value is configurable. Age time is measured in seconds. Response Time (seconds) The time it takes for an ARP request timeout. This value is configurable. Response time is measured in seconds. Retries The maximum number of times an ARP request is retried. This value is configurable. Cache Size The maximum number of entries in the ARP table. This value is configurable. Dynamic Renew Mode Displays whether the ARP component automatically attempts to renew dynamic ARP entries when they age out. Total Entry Count Current / The total entries in the ARP table and the peak entry count in the ARP table. Peak Static Entry Count Current / The static entry count in the ARP table and maximum static entry count in the ARP table. Max show arp switch This command displays the contents of the switch's Address Resolution Protocol (ARP) table. Format Mode show arp switch Privileged EXEC Term IP Address MAC Address Interface Definition The IP address of a device on a subnet attached to the switch. The hardware MAC address of that device. The routing slot/port associated with the device's ARP entry. IP Routing Commands This section describes the commands you use to enable and configure IP routing on the switch. routing This command enables IPv4 and IPv6 routing for an interface. You can view the current value for this function with the show ip brief command. The value is labeled as "Routing Mode." Default disabled Routing Commands 227