Netgear M4100-50G CLI Manual - Page 680
RADIUS Commands, show trapflags
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 680 highlights
ProSafe M4100 and M7100 Managed Switches Community Name IpAddress Mytrap 0.0.0.0 IPv6 Address 2001::1 Snmp Version Mode SNMPv2 Enable show trapflags show trapflags Use this command to display trap conditions. The command's display shows all the enabled OSPFv2 and OSPFv3 trapflags. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You do not have to reset the switch to implement the changes. Cold and warm start traps are always generated and cannot be disabled. Format Mode show trapflags Privileged EXEC Term Authentication Flag Link Up/Down Flag Multiple Users Flag Spanning Tree Flag ACL Traps DVMRP Traps OSPFv2 Traps OSPFv3 Traps PIM Traps Definition Can be enabled or disabled. The factory default is enabled. Indicates whether authentication failure traps will be sent. Can be enabled or disabled. The factory default is enabled. Indicates whether link status traps will be sent. Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will be sent when the same user ID is logged into the switch more than once at the same time (either through Telnet or the serial port). Can be enabled or disabled. The factory default is enabled. Indicates whether spanning tree traps are sent. Might be enabled or disabled. The factory default is disabled. Indicates whether ACL traps are sent. Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps are sent. Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. If any of the OSPF trap flags are not enabled, the command displays disabled. Otherwise, the command shows all the enabled OSPF traps' information. Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. If any of the OSPFv3 trap flags are not enabled, the command displays disabled. Otherwise, the command shows all the enabled OSPFv3 traps' information. Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps are sent. RADIUS Commands This section describes the commands you use to configure the switch to use a Remote Authentication Dial-In User Service (RADIUS) server on your network for authentication and accounting. Management Commands 680