Netgear M4100-50G CLI Manual - Page 366
ipv6 unreachables, ipv6 icmp error-interval, ipv6 nd router-preference
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 366 highlights
ProSafe M4100 and M7100 Managed Switches ipv6 nd router-preference This command will set the router preference to default. Format Mode no ipv6 router-preference Interface Config ipv6 unreachables Use this command to enable the generation of ICMPv6 Destination Unreachable messages. By default, the generation of ICMPv6 Destination Unreachable messages is enabled. Default Format Mode enable ipv6 unreachables Interface Config no ipv6 unreachables Use this command to prevent the generation of ICMPv6 Destination Unreachable messages. Format Mode no ipv6 unreachables Interface Config ipv6 icmp error-interval Use this command to limit the rate at which ICMPv6 error messages are sent. The rate limit is configured as a token bucket, with two configurable parameters, burst-size and burst-interval. The burst-interval specifies how often the token bucket is initialized with burst-size tokens. burst-interval is from 0 to 2,147,483,647 milliseconds (msec). The burst-size is the number of ICMPv6 error messages that can be sent during one burst-interval. The range is from 1 to 200 messages. To disable ICMP rate limiting, set burst-interval to zero (0). Default Format Mode • burst-interval of 1000 msec. • burst-size of 100 messages ipv6 icmp error-interval [] Global Config IPv6 Commands 366