Netgear M4100-50G CLI Manual - Page 694

ProSafe M4100 and M7100 Managed Switches debug tacacs packet Use the debug tacacs packet command to turn on TACACS+ packet debug. Default Format Mode Disabled debug tacacs packet [receive | transmit] Global Config no debug tacacs packet Use this command to turn off TACACS+ packet debug. Format Mode no debug tacacs packet Global Config tacacs-server host Use the tacacs-server host command in Global Configuration mode to configure a TACACS+ server. This command enters into the TACACS+ configuration mode. The parameter is the IP address or hostname of the TACACS+ server. To specify multiple hosts, multiple tacacs-server host commands can be used. Format Mode tacacs-server host Global Config no tacacs-server host Use the no tacacs-server host command to delete the specified hostname or IP address. The parameter is the IP address of the TACACS+ server. Format Mode no tacacs-server host Global Config tacacs-server key Use the tacacs-server key command to set the authentication and encryption key for all TACACS+ communications between the switch and the TACACS+ daemon. The parameter has a range of 0-128 characters and specifies the authentication and encryption key for all TACACS communications between the switch and the TACACS+ server. This key must match the key used on the TACACS+ daemon. Text-based configuration supports TACACS server's secrets in encrypted and non-encrypted format. When you save the configuration, these secret keys are stored in encrypted format only. If you want to enter the key in encrypted format, enter the key along with the encrypted Management Commands 694