Netgear M4100-50G CLI Manual - Page 564
DHCP Server Commands, ip dhcp pool, client-identifier
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 564 highlights
ProSafe M4100 and M7100 Managed Switches DHCP Server Commands This section describes the commands you to configure the DHCP server settings for the switch. DHCP uses UDP as its transport protocol and supports a number of features that facilitate in administration address allocations. ip dhcp pool This command configures a DHCP address pool name on a DHCP server and enters DHCP pool configuration mode. Default Format Mode none ip dhcp pool Global Config no ip dhcp pool This command removes the DHCP address pool. The name should be previously configured pool name. Format Mode no ip dhcp pool Global Config client-identifier This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client identifier is required instead of hardware addresses. The unique-identifier is a concatenation of the media type and the MAC address. For example, the Microsoft client identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet media type. For more information, refer to the "Address Resolution Protocol Parameters" section of RFC 1700, Assigned Numbers for a list of media type codes. Default Format Mode none client-identifier DHCP Pool Config no client-identifier This command deletes the client identifier. Format Mode no client-identifier DHCP Pool Config Utility Commands 564