Netgear M4100-50G CLI Manual - Page 273
bandwidth, capability opaque, clear ip ospf
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 273 highlights
ProSafe M4100 and M7100 Managed Switches bandwidth By default, OSPF computes the link cost of an interface as the ratio of the reference bandwidth to the interface bandwidth. Reference bandwidth is specified with the auto-cost command. For the OSPF link cost calculation, use the bandwidth command to specify the interface bandwidth. The bandwidth is specified in kilobits per second. If no bandwidth is configured, the bandwidth defaults to the actual interface bandwidth for port-based routing interfaces and to 10 Mbps for VLAN routing interfaces. This command does not affect the actual speed of an interface. Default Format Mode actual interface bandwidth bandwidth Interface Config no bandwidth Use this command to set the interface bandwidth to its default value. Format Mode no bandwidth Interface Config capability opaque Use this command to enable Opaque Capability on the Router. The information contained in Opaque LSAs might be used directly by OSPF or indirectly by an application wishing to distribute information throughout the OSPF domain. The 7000 series supports the storing and flooding of Opaque LSAs of different scopes. Default Format Mode disabled capability opaque Router OSPF Config no capability opaque Use this command to disable opaque capability on the router. Format Mode no capability opaque Router OSPF Config clear ip ospf Use this command to disable and reenable OSPF. Format Mode clear ip ospf Privileged EXEC Routing Commands 273