Netgear M4100-50G CLI Manual - Page 380
OSPFv3 Commands, no ipv6 ospf
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 380 highlights
ProSafe M4100 and M7100 Managed Switches clear ipv6 statistics Use this command to clear IPv6 statistics for all interfaces or for a specific interface, including loopback and tunnel interfaces. IPv6 statistics display in the output of the show ipv6 traffic command. If you do not specify an interface, the counters for all IPv6 traffic statistics reset to zero. Format Mode clear ipv6 statistics [{ | loopback | tunnel }] Privileged EXEC OSPFv3 Commands This section describes the commands you use to configure OSPFv3, which is a link-state routing protocol that you use to route traffic within a network. ipv6 ospf This command enables OSPF on a router interface or loopback interface. Default Format Mode disabled ipv6 ospf Interface Config no ipv6 ospf This command disables OSPF on a router interface or loopback interface. Format Mode no ipv6 ospf Interface Config ipv6 ospf area This command sets the OSPF area to which the specified router interface belongs. The is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in the range of . The uniquely identifies the area to which the interface connects. Assigning an area id, which does not exist on an interface, causes the area to be created with default values. Format Mode ipv6 ospf area Interface Config IPv6 Commands 380