Netgear M4100-50G CLI Manual - Page 149
set igmp interfacemode, set igmp fast-leave
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
ProSafe M4100 and M7100 Managed Switches Format Mode no set igmp VLAN Config set igmp interfacemode This command enables IGMP Snooping on all interfaces. If an interface has IGMP Snooping enabled and you enable this interface for routing or enlist it as a member of a port-channel (LAG), IGMP Snooping functionality is disabled on that interface. IGMP Snooping functionality is re-enabled if you disable routing or remove port-channel (LAG) membership from an interface that has IGMP Snooping enabled. Default Format Mode disabled set igmp interfacemode Global Config no set igmp interfacemode This command disables IGMP Snooping on all interfaces. Format Mode no set igmp interfacemode Global Config set igmp fast-leave This command enables or disables IGMP Snooping fast-leave admin mode on a selected interface or VLAN. Enabling fast-leave allows the switch to immediately remove the layer 2 LAN interface from its forwarding table entry upon receiving an IGMP leave message for that multicast group without first sending out MAC-based general queries to the interface. You should enable fast-leave admin mode only on VLANs where only one host is connected to each layer 2 LAN port. This prevents the inadvertent dropping of the other hosts that were connected to the same layer 2 LAN port but were still interested in receiving multicast traffic directed to that group. Also, fast-leave processing is supported only with IGMP version 2 hosts. Default Format Mode disabled set igmp fast-leave Interface Config Format Mode set igmp fast-leave VLAN Config Switching Commands 149