Netgear M4100-50G CLI Manual - Page 283
maximum-paths OSPF, passive-interface default OSPF, no redistribute, no maximum-paths
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 283 highlights
ProSafe M4100 and M7100 Managed Switches no redistribute This command configures OSPF protocol to prohibit redistribution of routes from the specified source protocol/routers. Format Mode no redistribute {rip | static | connected} [metric] [metric-type] [tag] [subnets] Router OSPF Config maximum-paths (OSPF) This command sets the number of paths that OSPF can report for a given destination where maxpaths is platform-dependent. Default Format Mode 4 maximum-paths Router OSPF Config no maximum-paths This command resets the number of paths that OSPF can report for a given destination back to its default value. Format Mode no maximum-paths Router OSPF Config passive-interface default (OSPF) Use this command to enable global passive mode by default for all interfaces. It overrides any interface level passive mode. OSPF will not form adjacencies over a passive interface. Default Format Mode disabled passive-interface default Router OSPF Config no passive-interface default Use this command to disable the global passive mode by default for all interfaces. Any interface previously configured to be passive reverts to non-passive mode. Format Mode no passive-interface default Router OSPF Config Routing Commands 283