Netgear M4100-50G CLI Manual - Page 270

ProSafe M4100 and M7100 Managed Switches composed of standard displayable, non-control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the type is encrypt, the key might be up to 16 bytes. Unauthenticated interfaces do not need an authentication key. If the type is encrypt, a key id in the range of 0 and 255 must be specified. The default value for authentication type is none. Neither the default password key nor the default key id are configured. Default Format Mode none area virtual-link authentication {none | {simple } | {encrypt }} Router OSPF Config no area virtual-link authentication This command configures the default authentication type for the OSPF virtual interface identified by and . The parameter is the Router ID of the neighbor. Format Mode no area virtual-link authentication Router OSPF Config area virtual-link dead-interval (OSPF) This command configures the dead interval for the OSPF virtual interface on the virtual interface identified by and . The parameter is the Router ID of the neighbor. The range for seconds is 1-65,535. Default Format Mode 40 area virtual-link dead-interval Router OSPF Config no area virtual-link dead-interval This command configures the default dead interval for the OSPF virtual interface on the virtual interface identified by and . The parameter is the Router ID of the neighbor. Format Mode no area virtual-link dead-interval Router OSPF Config Routing Commands 270