Netgear M4100-50G CLI Manual - Page 158
set igmp querier, set igmp querier query-interval
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
ProSafe M4100 and M7100 Managed Switches set igmp querier Use this command to enable IGMP Snooping Querier on the system, using Global Config mode, or on a VLAN. Using this command, you can specify the IP Address that the Snooping Querier switch should use as the source address while generating periodic queries. If a VLAN has IGMP Snooping Querier enabled and IGMP Snooping is operationally disabled on it, IGMP Snooping Querier functionality is disabled on that VLAN. IGMP Snooping functionality is re-enabled if IGMP Snooping is operational on the VLAN. Note: The Querier IP Address assigned for a VLAN takes preference over global configuration. The IGMP Snooping Querier application supports sending periodic general queries on the VLAN to solicit membership reports. Default Format Mode disabled set igmp querier [] [address ipv4_address] • Global Config • VLAN Mode no set igmp querier Use this command to disable IGMP Snooping Querier on the system. Use the optional address parameter to reset the querier address to 0.0.0.0. Format Mode no set igmp querier [] [address] • Global Config • VLAN Mode set igmp querier query-interval Use this command to set the IGMP Querier Query Interval time. It is the amount of time in seconds that the switch waits before sending another general query. Default Format Mode disabled set igmp querier query-interval Global Config Switching Commands 158