Netgear M4100-50G CLI Manual - Page 284
passive-interface OSPF, timers pacing flood, no passive-interface
View all Netgear M4100-50G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 284 highlights
ProSafe M4100 and M7100 Managed Switches passive-interface (OSPF) Use this command to set the interface or tunnel as passive. It overrides the global passive mode that is effective on the interface or tunnel. Default Format Mode disabled passive-interface {} Router OSPF Config no passive-interface Use this command to set the interface or tunnel as non-passive. It overrides the global passive mode that is effective on the interface or tunnel. Format Mode no passive-interface {} Router OSPF Config timers pacing flood To adjust the rate at which OSPFv2 sends LS Update packets, use this command in router OSPFv2 global configuration mode. OSPF distributes routing information in Link State Advertisements (LSAs), which are bundled into Link State Update (LS Update) packets. To reduce the likelihood of sending a neighbor more packets than it can buffer, OSPF rate limits the transmission of LS Update packets. By default, OSPF sends up to 30 updates per second on each interface (1/the pacing interval). Use this command to adjust this packet rate. Default Format Mode 33 milliseconds timers pacing flood milliseconds OSPFv2 Router Configuration Parameter milliseconds Description The average time between transmission of LS Update packets. The range is from 5 ms to 100 ms. The default is 33 ms. no timers pacing flood To revert LSA transmit pacing to the default rate, use the no timers pacing flood command. Format Mode no timers pacing flood OSPFv2 Router Configuration Routing Commands 284