Ricoh Aficio SP 9100DN Software Guide - Page 220

5. Monitoring and Configuring the Printer wiconfig Use the "wiconfig" command to make settings for IEEE 802.11b. View settings msh> wiconfig View IEEE 802.11b settings msh> wiconfig cardinfo • If IEEE 802.11b is not working correctly, its information is not displayed. Configuration msh> wiconfig "parameter" Parameter 5 mode {ap|adhoc|802.11adhoc} Value configured You can set the infrastructure mode (ap) , the 802.11 ad hoc mode (802.11adhoc), or the ad hoc mode (adhoc). The default is ad hoc mode. ssid "ID value" You can make settings for the SSID in the infrastructure mode. Usable characters are ASCII 0x20-0x7e (32 bytes). An SSID value is set automatically to the nearest access point if no setting is made. If no setting is made for the ad hoc mode, the same value as for the infrastructure mode or an ASSID value is automatically set. The default is blank. channel frequency "channel no." You can enable or disable the WEP function. To enable the WEP function, specify [on]; to disable it, specify [off]. To start the WEP function, enter the correct WEP key. The default is "11". key "key value" val {1|2|3|4} You can specify the WEP key when entering in hexadecimal. With a 64-bit WEP, you can use 10 digit hexadecimals. With a 128-bit WEP, you can use 26 digit hexadecimals. 218