Ricoh Aficio SP 9100DN Software Guide - Page 224
wins, Use the primary command to con a primary WINS server IPv4 address.
View all Ricoh Aficio SP 9100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
5. Monitoring and Configuring the Printer wins Use the "wins" command to configure WINS server settings. Viewing settings msh> wins • If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address is the valid address. Configuration msh> wins "interface_name" {on | off} • {on} means "active" and {off} means "inactive". • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11b interface unit is installed. 5 Interface name Interface configured ether Ethernet interface wlan IEEE 802.11b interface Address configuration Use the following command to configure a WINS server IP address: msh> wins "interface_name" {primary|secondary} "IP address" • Use the "primary" command to configure a primary WINS server IPv4 address. • Use the "secondary" command to configure a secondary WINS server IPv4 address. • Do not use "255.255.255.255" as the IPv4 address. NBT (NetBIOS over TCP/IP) Scope ID Selection You can specify the NBT scope ID. msh> wins "interface_name" scope "scope ID" • The scope ID can be entered using up to 31 alphanumeric characters. • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11b interface unit is installed. Interface name ether wlan Interface configured Ethernet interface IEEE 802.11b interface 222