Tripp Lite 0SU70032 Owner's Manual for 0SU70030 / 0SU70032 KVM Switches 933207 - Page 84

SNMP Events Table 9 SNMP Events Table The following table lists all recorded events. Event Text System Boot Server Busy ask for disconnect. Code 1010 1030 User login succeeded Login failed wrong user name or password Login not succeeded server busy Logout Disconnected by another user Hardware Failure 1040 1050 1060 1070 1110 1200 Hard reset power cycle command Viewer login 1220 1230 Viewer logout Global access disabled Block User Account Successful User Login Login is not successful - wrong user access level. 1240 1250 1260 2010 2020 Comment Reported upon device boot-up. Attempt to connect when another user is already connected. The second user has permission for takeover; sent before the second user actually takes over the session. On every successful user login to the device. Login failed due to wrong user name or password. Login denied because a user with higher permission is connected (takeover not allowed). User Logout (end of remote access session). Takeover has been successfully performed; the previous user has been disconnected. Device internal hardware failure. Try disconnecting any other attached device and reboot. If problem persists, contact technical support. Power cycle command issued; only relevant when a special power-cycle product is attached to the device (for exmple, KBPower). User connected in view-only mode (while another user is connected in a regular session). User connected in view-only mode has disconnected. Device has been blocked for access by an administrator; remote access is disabled until the device is unblocked. User blocked due to too many login attempts; failure per policy in configuration. Successful User Login. CONF_USER_EVENT_LOGIN_SUCCEEDED Login is not successful - wrong user access level. CONF_USER_EVENT_LOGIN_NOT_SUCCEEDED_WRONG_LEVEL 84 | Smart 108/116 IP