ZyXEL ES-2108PWR User Guide - Page 209

Figure 123 Management > Access Control > SNMP Chapter 27 Access Control The following table describes the labels in this screen. Table 84 Management > Access Control > SNMP LABEL DESCRIPTION General Setting Use this section to specify the SNMP version and community (password) values. Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or both (v3v2c). Get Community Set Community Trap Community Trap Destination Version IP Note: SNMP version 2c is backwards compatible with SNMP version 1. Enter the Get Community string, which is the password for the incoming Get- and GetNext- requests from the management station. The Get Community string is only used by SNMP managers using SNMP version 2c or lower. Enter the Set Community, which is the password for incoming Set- requests from the management station. The Set Community string is only used by SNMP managers using SNMP version 2c or lower. Enter the Trap Community string, which is the password sent with each trap to the SNMP manager. The Trap Community string is only used by SNMP managers using SNMP version 2c or lower. Use this section to configure where to send SNMP traps from the Switch. Specify the version of the SNMP trap messages. Enter the IP addresses of up to four managers to send your SNMP traps to. ES-2108 Series User's Guide 209