Brother International HS-5300 Service Manual - Page 109
reassembling
View all Brother International HS-5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
4.23.5 Lower MED sensor (Photo diode side) (1) Remove the Chute 1 ASSY. (See section 4.23.3) (2) Remove the Lower sensor holder by releasing the four hooks from the rear of the Main frame ASSY. Lower sensor holder ca Main frame ASSY ) / Hook vek / ------ e, ..- .1, N Hook Fig. 4.90 (3) Remove the MED sensor GL 380 ASSY by releasing the hook from the Lower sensor holder. Lower sensor holder MED sensor GL380 ASSY Fig. 4.91 Note: When reassembling, fit the MED sensor GL380 ASSY in the Lower sensor holder by matching the lower rib with the notch of the MED sensor GL380 ASSY. Ensure the harness is in the groove on the MED sensor GL380 ASSY of the Lower sensor holder. Carefully run the harness through the hole in the Main frame ASSY and secure it to the Math frame ASSY with the hook so that it is not caught in the Main frame ASSY. Check that the Lower sensor holder is securely fitted to the Main frame ASSY. III-57