Brother International HS-5300 Service Manual - Page 16
alternately
View all Brother International HS-5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
4.10.6 Online Button The Online button alternately turns the printer on-line and off-line. If you press this button during printing, the printer immediately stops printing and ejects the paper. Pressing this button again prints the rest of the print data. If you want to cancel printing, cancel the print job in your application first and then reset the printer. When the printer becomes off-line because of an error, the printer can recover from some errors and return to on-line by pressing this button. When performing cleaning or resetting, the printer must be set to off-line first. 4.10.7 Reset Button The Reset button is valid only in the off-line mode. The printer is reset and restored to the user default settings. Note: Remember that the Reset button clears data from the printer memory. 4.10.8 FF/Cont Button This button is valid only in the off-line mode. If the Data LED is on, pressing the FF/Cont button prints any data remaining in the printer after turning the printer off-line. When you select manual feed in your application, the printer alerts you to load paper in the manual feed slot by blinking the Manual LED. Press this button to start feeding the paper. If a recoverable error occurs, press the FF/Cont button to recover from the error and return to the on-line state. 4.10.9 Shift + Test Button Pressing the Test button while holding down the Shift button starts the test print. Check the printed test page and if you find any printing problems, perform the print head cleaning as described below. 4.10.10 Shift + Clean Button Pressing the Clean button while holding down the Shift button starts head cleaning. If you see any problems on printouts, clean the print head and try again. Note: Do not open the top cover during the head cleaning operation. 4.10.11 Test Print Mode The printer has the following test print modes. 1. Keep the Online button depressed until all four LEDs light. Then, release the button. The printer enters test print mode. The Alarm LED blinks to indicate that the first choice, Print Config, is selected. See the table below. 1-10